Plug the Bark Pick-Up Unit
into the Control Unit. Connect the Electric Water Valve to the Control
Unit. And plug the Control Unit into the outlet. The red Power indicator
light on the Control Unit labeled "P" should be lit whenever the
Control Unit is plugged in. If it is not, or if it ever goes out, then you
have a short in your wires leading to the Electric Water Valve and your
fuse has blown. The fuse will require replacement with the same type at
the same rating, and may be found at Radio Shack. The red Correction
indicator light will light up whenever the Bark Pick-Up Unit has been
triggered. If the water has been turned back on, the system should
activate and spray the kennels down automatically when the Control Unit is
plugged in. If this doesn't happen, check all connections and be sure that
the water is turned back on. Also refer to the instructions for the
Electric Water Valve for electrical versus manual operation. Tap the
microphone on the Bark Pick-Up Unit to test the microphone. Adjust the
spray controls on the Impulse Sprinkler Head as per its instructions for
the best kennel spray coverage.
Next
- Step 8: Custom Adjustments - Bark Pick-Up Sensitivity and Water
Correction Spray Timing
We build our products in the USA. 